Home > Performance Parts > Carburation & Timing >

Isolator w/Pulse Fitting



 
Our Price: $7.99


Product Code: PULSEISO
Qty:

Description
 

Isolator w/Pulse Fitting


Need to get engine pulse to run your fuel pump? Dont want to mess with drilling and tapping your isolator or valve cover? This part is for you!


Most people that try to drill and tap these on their own end up breaking them, avoid the hassle and buy it once.


Average Rating: 5 of 5 Total Reviews: 5 Write a review »

  0 of 0 people found the following review helpful:
 
Very satisfied. July 10, 2016
Reviewer: John Kohl from Worton, MD United States  
What I needed for my restoration project. 1996 Yahama gas cart.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
420 predator swap June 28, 2016
Reviewer: Rob Bowser from Midland City, AL United States  
Make sure you run a T fitting in the fuel line back to the tank for a return or you will have fuel over flow.  The pulse fitting fit just like the factory one and works absolutely perfect.  *Do not cheap out on this and try to run pulse fitting from the valve cover you will have poor signal and build crank case pressure that will cause seal failure and poor performance.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
Runs stock fuel pump May 11, 2016
Reviewer: james roberts from flatgap, KY United States  
Quality part, very well made.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Perfect fit September 8, 2015
Reviewer: Toby Pratt from Westland, MI United States  
could sell some vacuum hose adaptors to go with it too.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
isolator July 31, 2015
Reviewer: albert whipple from woodward, OK United States  
Works great

Was this review helpful to you?